Draw a leader line.
Leader lines can be Polylines (Straight segments) or Splines (curved)
After indicating or specifying the first point, Caddie will ask on the command bar if a Polyline or Spline leader is required. Type Either P (Polyline) or S (Spline). Continue entering the next leader node and terminate with the Option-End command from the CSM . This will cause the leader arrow to be drawn. The results will look similar to those show below.
Polyline Leader |
Spline Leader |
To set the size, pens, arrows etc. use Leader line parameter set
Shown below are the leader heads available. In addition there is a blank head.